Artesan Regent 10 Jet Whirlpool Corner Bath

Hi

Guide below.

ELECTRICAL CONNECTION

All electrical connections must MUST be carried out by a qualified electrician and electrical wiring and ancillary equipment must conform to British Standards and CE.

The power supply can run from 2 sources:

Source 1: From the main circuit board run correctly sized twin and earth cable to a residual current circuit breaker (RCCB) situated outside the bathroom. Continue the cable into the bathroom and connect to pump. (RCCBs can be purchased through ourselves: specification 25amp 240v AC 30MA trip).

Source 2: From your socket ring main (13 amp) run correctly sized twin and earth cable to a residual current circuit breaker (RCCB) situated outside the bathroom. Continue the cable into the bathroom as above. Please ensure that the fuse in a fused spur is 13 amp for all pumped whirlpool systems. Should you have an air spa only system then a 5 amp is sufficient.

If you have chosen a dual system with air spa, the blower provided is positioned in a convenient place on the floor and the blower hose and pneumatic tube attached. The blower can then be connected to the same 13 amp fused spur as the pump.

For our electronic systems with pre-fitted touch pad, all appliances (pump, blower, light etc.) have been pre-wired and tested in the factory before dispatch. The mains cable (pre fitted) must be connected to a 13 amp fused spur.

Chromotherapy lighting can be connected to the lighting circuit if convenient or a separate 3 amp fused spur should be provided for the light.